AWEA MECHANTRONIC

LP-25YZF Series Bridge Type 5-Face Machining Center :

Prinit this page LP-3025YZF LP-4025YZF LP-5025YZF LP-6025YZF
CAPACITY
X-axis travel 3,000 mm 4,000 mm 5,000 mm 6,000 mm
Y-axis travel 3,200 mm
Z-axis travel 1,000 mm
Dist. form spindle nose to table top 200 ~ 1,200 mm
Dist. between columns 2,700 mm
WORKING TABLE
Table size ( X direction ) 3,020 mm 4,020 mm 5,020 mm 6,020 mm
Table size ( Y direction ) 2,400 mm
Table load capacity 12,000 kg 15,000 kg 18,000 kg 20,000 kg
SPINDLE
Spindle motor ( cont. / 30 min. ) 22 / 26 kW ( 30 / 35 HP )
Spindle speed 4,000 rpm ( Std. )
Built-in 6,000 / 8,000 rpm ( Opt. )
Direct Drive 8,000 / 10,000 rpm ( Opt. )
Spindle taper BT50 ( ISO50 ) / DIN69871-A ( Opt. )
FEED RATE
X-axis rapid feedrate 20,000 mm/min. 15,000 mm/min. 10,000 mm/min. 10,000 mm/min.
Y-axis rapid feedrate 15,000 mm/min.
Z-axis rapid feedrate 10,000 mm/min.
Cutting feedrate 1 ~ 10,000 mm/min. 1 ~ 5,000 mm/min.
TOOL MAGAZINE
Tool magazine capacity 32 ( 60 / 90 / 120 Opt. )
Max. tool diameter / adj. pocket empty Ø 127 / Ø 215 mm
Max. tool length ( from gauge line ) 350 mm
Max. tool weight 20 kg
ACCURACY
Positioning accuracy ( JIS B 6338 ) ± 0.015 mm
/ Full Travel
Positioning accuracy ( VDI 3441 ) P ≤ 0.025 mm
/ Full Travel
P ≤ 0.030 mm
/ Full Travel
P ≤ 0.040 mm
/ Full Travel
P ≤ 0.050 mm
/ Full Travel
Repeatability ( JIS B 6338 ) ± 0.003 mm
Repeatability ( VDI 3441 ) Ps ≤ 0.020 mm Ps ≤ 0.025 mm Ps ≤ 0.030 mm Ps ≤ 0.035 mm
GENERAL
Power requirement 220 ± 10 %
Pneumatic pressure requirement ( min. ) 5 ~ 8 ( 5 ) kg / cm²
Hydraulic unit tank capacity ( pump ) 120 liter ( 10 HP )
Lubrication oil tank capacity 6 liter
Coolant tank capacity ( pump ) 750 liter ( 1.5 HP )
Machine weight 39,000 kg 44,000 kg 49,000 kg 53,000 kg

Specifications are subject to change without notice.