AWEA MECHANTRONIC

LP-21 Series Bridge Type Vertical Machining Center :

Print this page LP-3021 LP-4021 LP-5021 LP-6021
CAPACITY
X-axis travel 3,000 mm 4,000 mm 5,000 mm 6,000 mm
Y-axis travel 2,100 mm ( 2,500 mm Opt. )
Z-axis travel 760 mm ( 1,000 / 1,200 / 1,400 mm Opt. )
Dist. form spindle nose to table top 240 ~ 1,000 mm ( 200 ~ 1,200 mm / 200 ~ 1,400 mm / 200 ~ 1,600 mm Opt. )
Dist. between columns 2,300 mm
WORKING TABLE
Table size ( X direction ) 3,020 mm 4,020 mm 5,020 mm 6,020 mm
Table size ( Y direction ) 2,010 mm
Table load capacity 10,000 kg 12,000 kg 15,000 kg 18,000 kg
SPINDLE
Spindle motor ( cont. / 30 min. ) 22 / 26 kW ( 30 / 35 HP )
Spindle speed 6,000 rpm ( Std. )
Z-axis : 1,000 / 1,200 / 1,400 mm ;
Gear 4,000 / 5,000 rpm ( Opt. )
Built-in 6,000 / 8,000 rpm ( Opt. )
Direct Drive 8,000 / 10,000 rpm ( Opt. )
Spindle taper BT50 ( ISO50 ) / DIN69871-A ( Opt. )
FEED RATE
X-axis rapid feedrate 20,000 mm/min. 15,000 mm/min. 10,000 mm/min. 10,000 mm/min.
Y-axis rapid feedrate 15,000 mm/min.
Z-axis rapid feedrate 15,000 mm/min.
Cutting feedrate 1 ~ 10,000 mm/min. 1 ~ 5,000 mm/min.
TOOL MAGAZINE
Tool magazine capacity 32 ( 60 / 90 / 120 Opt. )
Max. tool diameter / adj. pocket empty Ø 127 / Ø 215 mm
Max. tool length ( from gauge line ) 350 mm
Max. tool weight 20 kg
ACCURACY
Positioning accuracy ( JIS B 6338 ) ± 0.015 mm / Full Travel
Positioning accuracy ( VDI 3441 ) P ≤ 0.025 mm /
Full Travel
P ≤ 0.030 mm /
Full Travel
P ≤ 0.040 mm /
Full Travel
P ≤ 0.050 mm /
Full Travel
Repeatability ( JIS B 6338 ) ± 0.003 mm
Repeatability ( VDI 3441 ) Ps ≤ 0.020 mm Ps ≤ 0.025 mm Ps ≤ 0.030 mm Ps ≤ 0.035 mm
GENERAL
Power requirement 220 ± 10 %
Pneumatic pressure requirement ( min. ) 5 ~ 8 ( 5 ) kg / cm²
Hydraulic unit tank capacity ( pump ) 120 liter ( 10 HP )
Lubrication oil tank capacity 6 liter
Coolant tank capacity ( pump ) 650 liter ( 1.5 HP )
Machine weight 33,000 kg 37,500 kg 41,000 kg 45,000 kg

Specifications are subject to change without notice.